Campbell Hausfeld PW1625 Manual Del Usuario página 3

Safety Guidelines (Continued)
TOOL USE AND CARE
Do not use pressure that exceeds the operating
pressure of any of the parts (hoses, fi ttings, etc.)
in the pressurized system. Ensure all equipment and accessories are
rated to withstand the maximum working pressure of the unit.
a. Maintain the tool with care. A properly maintained tool
reduces the risk of problems and is easier to control.
b. Ensure safety devices are operating properly before each
use. DO NOT remove or modify any part of the gun or unit.
c. NEVER operate the machine without all components properly
connected to the machine (handle, gun/wand assembly,
nozzle, etc.).
d. Point gun in safe direction. Unit will start spraying when
trigger is squeezed if "On/Off" switch is in "ON" position.
e. Know how to stop this product and bleed pressure quickly.
Be thoroughly familiar with the controls.
f. ALWAYS engage the trigger safety latch in the safe position
when spraying is stopped even if only for a few moments.
g. NEVER permanently engage the trigger mechanism on the
gun.
h. ALWAYS follow detergent manufacturer's label
recommendations for proper use of detergents. Always
protect eyes, skin, and respiratory system from detergent
use.
i. NEVER disconnect the high pressure discharge hose from
the machine while the system is pressurized. To depressurize
machine, turn power and water supply off, then press the gun
trigger 2-3 times.
j. Unplug unit when not in use.
k. Follow the maintenance instructions specified in the manual.
Equipment damage:
l. ALWAYS turn water supply "ON" before turning pressure
washer "ON." Running pump dry causes serious damage.
m. Do not operate the pressure washer with the inlet water
screen removed. Keep screen clear of debris and sediment.
n. NEVER operate pressure washer with broken or missing
parts. Check equipment regularly and repair or replace worn
or damaged parts immediately.
o. Use only the lances supplied with this machine.
p. NEVER leave the wand unattended while the machine is
running.
q. ALWAYS hold gun and wand firmly when starting and
operating the machine.
r. Release the trigger when changing from high to low pressure
modes. Failure to do so could result in damage to the nozzle.
s. NEVER store the pressure washer outdoors or where it could
freeze. Freezing temperatures can seriously damage the
pump.
t. Pressure washer is not meant to pump hot water. Do not
connect to hot water supply.
Models: PW1625, PW1825, PW1835
SERVICE
a. When servicing a tool, use only identical replacement parts.
Use only authorized parts.
Servicing of a Double-Insulated Appliance
In a double-insulated product,
two systems of insulation are
provided instead of grounding.
No grounding means are provided
for a double-insulated product,
nor should grounding means be
added to the product. Servicing a
double-insulated product requires
extreme care and knowledge of
the system, and should be done
only by qualified service personnel.
Replacement parts for a double-
insulated product must be identical to the original parts. A
double-insulated product is marked with the words "Double
Insulation" or "Double Insulated." Product may also be marked
with symbol shown above.
The DANGER, WARNING, CAUTION, and NOTICE
notifications and instructions in this manual cannot cover
all possible conditions and situations that may occur.
It must be understood by the operator that caution is a
factor which cannot be built into this product, but must be
supplied by the operator.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
3
Double Insulated Symbol
www.campbellhausfeld.com