Basic Operations (continued)
Switch
On/Off Trigger Switch with Switch Lock-On Button - To
start the tool, squeeze the trigger. If desired, push in the
Lock-On Button to keep the machine ON. Squeeze and
release the trigger a second time to turn machine OFF.
Adjusting the Stationary Vise
The stationary vise can be repositioned by loosening the
adjustment bolts, sliding the fence to the desired position
and retightening the bolts. The maximum width capacity
is approximately 8-1/4" at 90° and 5" at 45°.
Changing the Cutting Angle
The vise can be adjusted from 0° to 45° left and right.
1. Using the arbor wrench loosen the two bolts on the
vise, then set the working surface on the vise at the
desired angle.
2. Tighten the two bolts.
Quick Lock-Release Vise
This tool is equipped with a lock-release vise for easy
and fast clamping of the material. Raise lever for fast
movement of vise. Lower lever and turn crank for work-
piece clamping.
Switch Interlock
Button
Wrench
Base
M10 Hexagon
Socket Head Bolts
14
On/Off
Trigger
Switch
Vise Stop
Adjustment
Stationary
Bolts
Vise
Screw Shaft
Release Lever