Setting The Mode; Oven Vent - Siemens HE2415U Manual De Uso Y Cuidado

Setting the Cooking Mode
1. Touch COOKING MODE.
2. BAKE will flash in the display.
If no further setting is made within 5 seconds, control
will beep and flash. If this occurs, press START.
3. To change the cooking mode, turn knob.
4. Push START.
The selected mode will appear in the display, along
with the default temperature for that mode, which
will be blinking.
5. To select a different temperature, turn knob to
the right or left (in 5° increments) to desired
temperature.
6. Touch START. If START is not touched, oven will
automatically turn on in 5 seconds.
7. The display alternates between the cooking mode
and preheat.
The preheated temperature is also displayed,
starting at 100ºF. The actual temperature increases
until set temperature is reached, at which point the
oven will beep.
8. To change temperature during cooking, touch
Temperature. Turn the knob to select new
Temperature and press START.
9. Once cooking has been completed, touch OFF to turn
off oven.
Note: After the oven has been turned off, HOT appears in
the display where the cooking mode was. This is to
indicate that the oven is off but still hot. When the oven
temperature drops below 176° F, HOT is no longer seen in
the display.
Oven Operation Time
The oven will automatically shut off after 12 hours (24
hours if the time format is set for 24 hours in the SELECT
FUNCTION section).

Oven Vent

The oven vent is located below the display above the rear
left cooktop element.
CAUTION:
This area may become hot
when the oven is in use.
It is normal to see steam escaping from the vent and
condensation may collect on the backguard and cooktop.
Do not block the vent as it is important for air circulation.
Oven Operation - Setting the Mode
6: 35 6: 35 6: 35 6: 35 6: 35
380º 380º 380º 380º 380º
PM
1 1 1 1 1 00 00 00 00 00 B B B B B AKE AKE AKE
AKE AKE
HELPFUL TIP
To back out of a current
mode, push OFF.
Selecting OFF when not
in a setting up mode will
stop oven function.