Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
1. DISPENSING COLD WATER
2. DISPENSING ROOM TEMPERATURE WATER
3. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE: This model Water Dispenser left the factory with
the cold water temperature control factory "default setting"
positioned for "Energy Star" compliance (identified to the
side). This setting will deliver cold water temperatures
between 8°C ~ 10°C (46.4°F ~ 50°F) The cold water
temperature can be adjusted, (using a flat screwdriver) by
rotating the adjustment screw clockwise or anti-clockwise
between "High" (cool) and "Low" (colder) until the desired
temperature is reached. NOTE: Any change/adjustment
to the cold water temperature control may effect Energy
Star efficiency. If the water dispenser is not dispensing
water, there could be a possible ice build-up due to the
cold water temperature control being set too cold. If this
happens, unplug the dispenser overnight and then reset.
Set thermostat to high, slowly increasing based on your use
and need for cold water.
ENERGY STAR FACTORY
DEFAULT SETTING
TEMP
High
Low
COLD WATER
Publicidad
Tabla de contenido
