ABC Design Condor 4S Manual Del Usuario página 13

16. Fitting the adapter to the carrycot
Fit the adapter onto the carrycot from below until it engages in the brackets provided.
Make sure that the adapter is securely engaged.
17. Inserting the mattress
Insert the mattress in the cover.
Lay the mattress on the base.
NB: The mattress is wedge-shaped. Make sure that the raised part is at the head end.
18. Adjusting the handle
To adjust the handle, press the buttons on both sides.
Now you can adjust the handle.
19. Fitting the apron
Fit the closed end of the apron over the lower end of the carrycot.
Extend the apron over the cot.
Secure the ends of the apron with the Velcro fastening provided on the outside of the hood.
20. Mounting the carrycot on the pushchair
The adapter is fitted to the long side of the carrycot.
Place the carrycot onto the pushchair so that the catch mechanism engages.
To remove the carrycot, press the buttons on the adapter on both sides of the cot and lift the cot up to
release it from the catches.
CAUTION: Always check before use that the carrycot is correctly secured
to the pushchair.
21. Adjusting the handle
Push the button upwards to adjust the height of the handle.
When the handle is at the required height, let go of the button again so that the handle will remain locked
in this position.
22. Folding the pushchair
To fold the pushchair, bring the handle to its lowest position as described in point 21, holding the button
(1) down as you do so.
Now rotate the knob (2) to the left and push the handle down.
Now you can fold up the pushchair.
Note: To unfold the pushchair, follow the instructions in point 1 "Opening the pushchair".
CAUTION: Ensure that all the catches are engaged before use.
EN - 08