Installation Instructions - Ebode LightSpeaker AudioRock Guia Del Usuario

Installation Instruction
Step 1: After the battery has been charged, install it into the
battery compartment. Be sure it is pushed all the way in.
Secure the battery by sliding the tabs over the battery until
they are pointing straight at each other.
Step 2: Be sure the zone switch on the back of your
AudioRock is set to zone 1 unless you are setting up
a two zone system. If you intend to set up a two zone
system, be certain the zone switch is set to the number
corresponding to the zone you intend to place it in.
11