Pairing the AudioRock to the Transmitter
Before you can begin using and enjoying your new
portable wireless AudioRock system, it is necessary to
"teach" your AudioRock the identity of the transmitter you
are using; this teaching is called "pairing" and is very easy
to do.
Step 1: With the Transmitter power on (LED on front will be
lit), find and press the pairing button on the back of the unit.
You may need a sharp object, like a pen, to press the button
in. When you do, you will see the LED on the front of the
transmitter flash.
This means the unit is in the "pairing" mode.
Step 2: Quickly set the power switch, located at the back
of your AudioRock, to "ON" and press the pairing button
also located on the back of the AudioRock.
You have a total of 30
seconds to get this done.
If you take too long, leave
the units you have already
switched the power on, ON.
Press the pairing button
again and proceed through
the other areas.
12