GE WPGT9350 Manual Del Propietario E Instrucciones De Instalación página 10

About the
Wash Options
Adjusting the
Time Settings
10
The Wash Options allow you to set options for the
current wash cycle only. After you have made all
desired changes, press OK.
Delay Start – Use to delay the start of your washer.
Press DELAY START to change the delay time.
Presoak – Soaks the clothes before beginning the
wash cycle. Press PRESOAK to change the soaking
time.
Additives – Appears ONLY AFTER a presoak has
been selected. Uses the contents of the Pretreat
dispenser tray for a presoak. When selected, the
washer will drain after the presoak and fill again for
the wash cycle. Press ADDITIVES to specify if you
will NOT be using a Pretreat additive or if you do
not want the washer to drain after presoak.
Extra Rinse – Adds an additional cold rinse to the
end of the wash cycle.
Signal – Alerts you that the cycle is complete. The
clothes should be removed when the beeper goes
off so wrinkles won't set in. Touch SIGNAL to
select the volume or to turn the beeper off. The
new volume will be saved as the default setting.
Extended Spin – Increases the length of the spin
time to extract more water from your clothes.
NOTE: The water level will vary depending on the
load size and type. The washer uses adaptive filling
and load sensing to provide the appropriate water
level for effective and efficient wash performance
and energy usage.
NOTE: Water may not cover the top level of the
clothes. This is normal for high efficiency washers.
The water fill is optimized by the system for better
wash performance.
You can adjust the length of the wash cycle by
changing the cycle time, adding a Delay Start
or adding an Extending Spin.
Cycle Time – Press CYCLE TIME; then use
the arrows to select more or less time.
Delay Time – Use to add a Delay Start to the
beginning of the wash cycle. Press DELAY
TIME; then set the DELAY START time in the
OPTIONS menu.
Extended Spin – Increases the length of the spin
time to extract more water from your clothes. Press
EXTENDED SPIN; then select EXTENDED SPIN
from the OPTIONS menu.
NOTE: After the wash cycle begins, you will not
be able to change the Cycle Time or Delay Time.
The washer will beep twice if you try to change
the times after the cycle begins.
Summary Screen
ge.com
OPTIONS
DELAY
1
HR
START
PRE
15
MIN
SOAK
ADDITIVES
ARE YOU USING
PRESOAK ADDITIVES ?
YES
ADJUST TIME SETTINGS
CYCLE TIME
EXTENDED SPIN
OK
EXTENDED
SPIN
EXTRA
RINSE
SIGNAL
NO
DELAY TIME