Teach-In To Alpha Ip Base Station - Alpha IP RTA 61001-N1 Guia De Inicio Rapido

5.1.1 Teach-in to Alpha IP Base Station

For teach-in, keep a minimum distance of 50 cm between the devices.
The teach-in process can be interrupted by shortly pressing the teach-in
key again. This is confirmed by a short flash in red colour of the device
LED.
If no teach-in is performed, the teach-in mode is finished automatically
after 30 seconds.
If the room control unit Analog shall be taught-in to the Alpha IP Base station, the
two devices to be linked must be set to teach-in mode.
1. Select the desired channel at the Alpha IP base station (see Alpha IP Base station
instructions).
2. Press the System key of the Alpha IP base station for 4 seconds, until the LED of
the System key
3. flashes rapidly in orange.
9 The device LED starts to flash in orange.
4. Take off the room control unit Analog from the installation bottom (see fig. 5
page 5).
5. Pull out the insulating strip from the battery compartment, or insert batteries (see
Commissioning
31