Teach-In To Alpha Ip Access Point - Alpha IP RTA 61001-N1 Guia De Inicio Rapido

Ocultar thumbs Ver también para RTA 61001-N1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 98
Commissioning
fig. 6 page 5). If batteries have already been inserted, press the system key
(C) for at least 4 seconds in order to activate the teach-in mode.
9 The teach-in mode is activated automatically for 3 minutes.
9 The device LED flashes in orange.
The LED will light up in green after a successful teach-in process. If the
LED lights up red, repeat the process.

5.1.2 Teach-in to Alpha IP Access Point

For a control via the Alpha IP app, the teach-in must of the RTA 61001-N1 must
be performed via the Access Point (HAP 21001). Teach-in the device as follows:
Ö The Alpha IP Access Point has been set up via the Alpha IP App (see instructions
HAP 21001).
1. Open the Alpha IP app on the smart phone.
2. Select the menu item Teach-in device.
3. Release the room control unit Analog from the installation bottom (see fig. 5
page 5).
4. Pull out the insulating strip from the battery compartment, or insert batteries (see
fig. 6 page 5). If batteries have already been inserted, press the system key
(C) for at least 4 seconds in order to activate the teach-in mode.
5. The device is displayed automatically in the Alpha IP app.
32

Publicidad

Tabla de contenido
loading

Productos relacionados para Alpha IP RTA 61001-N1

Tabla de contenido