Installation In Flush-Type Box - Alpha IP RTA 61001-N1 Guia De Inicio Rapido

Commissioning
5. Mark two diagonally opposite bore holes using the installation bottom.
If wood walls are present, the screws can be screwed directly into the
wood. Pre-drilling with a 1.5 mm wood drill can facilitate the installation
of the screws.
6. For stone walls, drill the holes at the marked positions with a 5 mm masonry drill.
7. Insert dowels into the bores.
8. Install the installation bottom using the supplied screws (see fig. 4a page 4).
9. Position the room control unit Analog onto the installation bottom and latch it
in (see fig. 5 page 5).

5.2.2 Installation in flush-type box

The fixing holes on the installation bottom can be used for installation on a flush-
type box (see fig. 4b page 4).
1. If necessary, release the device from the installation bottom with a suitable screw-
driver (see fig. 5 page 5).
2. Align the installation bottom horizontally on the flush-type box.
3. Install the installation bottom with suitable screws (see page 4 fig. 2b).
4. Position the room control unit Analog onto the installation bottom and latch it
into the clips (see fig. 5 page 5).
34