Velleman K8057 Manual De Instrucciones página 6

Receiver instructions
Receiver instructions
At power up, LD4 turns on, hereby indicating that the unit is operational. At this time, it will respond to the default code
emitted by the transmitter. If you have changed the code of your transmitter (recommended), then the receiver needs to
'learn' the new code.
To learn a remote :
1. Hold 'setup' button, LD3 turns on after a few seconds.
2. Hold any remote button.
3. LD4 lights when the code has been grabbed.
4. Release 'setup' button.
Repeat steps 1 through 4 so the receiver can learn the codes for other transmitters
31 transmitters can be stored.
If the memory is full, LD3 and LD4 will flash simultaneously when 'setup' button is pressed
To remove all remotes from memory :
1. Turn off the power (remove power cord).
2. Hold 'setup' button
3. Turn on power
6
DISCONNECT RELAY OUTPUTS DURING SETUP!
!