Installing The Gmos-Lan-09; Initializing The Gmos-Lan-09 - Axxess GMOS-LAN-09 Instrucciones De Instalación

CONNECTIONS TO BE MADE
(d) 12-pin pre-wired ASWC-1 harness:
• This harness is to be used in conjunction with the optional ASWC-1 (not included) to
retain steering wheel controls. If the ASWC-1 is not being used, disregard this harness.
If it will be used, please refer to the ASWC-1 instructions for radio connections and
programming.
Note: Disregard the harness that comes with the ASWC-1.
To the aftermarket radio:
• Connect the Red wire to the accessory wire.
(Figure A)
(CONT)
To the vehicle:
Note: The Canyon/Colorado may be different.
• Connect the Green/Black wire to Green/Black wire in the black, 8-pin connector below
the steering column, on the bottom side. (Figure A)
Note: The relay attached to the GMOS-LAN-09 harness is only for audible turn signal
clicks. No extra steps are required to retain this feature, so leave the relay as-is.
• Connect the 16-pin harness with stripped leads into the interface.
Green/Black wire
• Connect the 14-pin, 16-pin and 20-pin harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
Attention! If the interface loses power for any reason, the following steps will need to be
performed again. Also, if installing an ASWC-1 connect it after you initialize and test the
interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test the interface/radio
for proper operation.
CONNECTIONS TO BE MADE

INSTALLING THE GMOS-LAN-09

INITIALIZING THE GMOS-LAN-09

(CONT)
REV. 9/8/2017 INSTGMOS-LAN-09
3