Fairing Disassembly - Metra 95-HDIF Instrucciones De Instalación

Attention! Due to how involving it is to
remove the fairing, it is highly advisable
to read the steps beforehand to get a clear
understanding of what is to be expected. If
the process seems too complex, it is best to
seek a professional to perform this job. Also,
it would be best if pictures are taken during
the process, and all hardware bagged and
tagged. Take notice also how the factory
wiring is routed throughout the fairing. This
will have to be duplicated in reassembly.
1. Remove (4) T27 Torx screws from the
inner fairing. (Figure A)
2. Remove (3) T27 Torx screws securing the
outer fairing, removing the middle one
last. Once the middle screw is removed
the outer fairing will be loose. Take
caution not to drop the outer fairing and
windshield. (Figure B)
2

FAIRING DISASSEMBLY

(Figure A)
(Figure B)
3. Unplug the headlight, then remove the
outer fairing. (Figure C)
4. Remove (4) 3/16 Allen screws securing
the radio. Unplug the radio, then slide
the radio out toward the rear of the bike.
(Figure D)
5. Unplug the left and right turn signal
indicators.
Continued on the next page
(Figure C)
(Figure D)
|
1.800.221.0932 MetraOnline.com