Axxess ASWC-TOY-LEX Instrucciones De Instalación página 2

Applications
TOYOTA
Avalon 2003-2004
Prius 2001-2003
Sienna 1999-2003
Table of Contents
Installation
– Into vehicle ............................................................................................2
– To radio . ............................................................................................. 2-3
Programming ...........................................................................................3
Troubleshooting .......................................................................................3
Radio legend ............................................................................................4
Resetting the SWC buttons......................................................................4
LEXUS
GS300 1998-2005
GS430 2001-2005
LX470 2001-2002
SC430 2002-2009
ASWC-TOY-LEX
Into vehicle
1) Connect the Black wire of the ASWC-TOY-LEX to ground. You may use the same
grounding point as the aftermarket radio.
2) Connect the Red wire of the ASWC-TOY-LEX to a 12 volt accessory wire, one that turns
on and off with the ignition key.
3) Depending on the vehicle you are in connect either the 6-pin or 12-pin connector to the
mating vehicle harness.
To radio
1) For the radios below, plug the included female 3.5mm connector with the Brown and
Brown/White wires into the male 3.5mm connector of the ASWC-TOY-LEX harness.
• For Eclipse radios: Connect the Eclipse steering wheel control wires (normally
Brown and Brown/Black) to the Brown and Brown/White wires of the
ASWC-TOY-LEX. Brown of the ASWC-TOY-LEX goes to the Brown/Black of the
Eclipse and Brown/White of the ASWC-TOY-LEX goes to the Brown of the Eclipse.
• For Metra OE: Connect the SWC Key 1 wire (Grey) to the Brown wire of the
ASWC-TOY-LEX. Isolate and tape the Brown/White wire, it will not be used.
• For Kenwood or select JVC's with a Blue/Yellow steering wheel control wire:
Connect the Kenwood/JVC steering wheel control wire to the Brown wire of the
ASWC-TOY-LEX. Isolate and tape the Brown/White wire, it will not be used.
2
Installation