Wiring Diagrams; Electrical Connections Via Safety Isolating Transformer - JOVENTA DAS Serie Guia De Instalacion

Wiring Diagrams

Figure 4: ON/OFF and Floating Control
(1) ON/OFF
(2) Floating
Figure 5: Parallel connection
(1) ON/OFF
(2) Floating
Figure 6: Auxiliary switches
(1) Auxiliary switch factory set at 10° CW
(2) Auxiliary switch factory set at 80° CW
(3) Actuator at 0°position
Figure 7: Potentiometer

Electrical connections via safety isolating transformer

• In order to make the electrical connections, loosen screw (Fig. 1 a.) and
remove the cover.
• Actuator wiring diagram
• Parallel connection
• Auxiliary switches
• Feedback potentiometer
• The electrical installation work should be carried out by a qualified
electrician.
• Wrong connections can damage the equipment. Check the connections
before energizing the power supply.
• Local accident prevention regulations should always be adhered to when
installing the actuators.
• The actuator moves about slightly while it is working so it is important to
use flexible leads for the electrical connections.
according to terminal connection (Fig. 4).
according to terminal connection (Fig. 5).
according to terminal connection (Fig. 6).
according to terminal connection (Fig. 7).
DAS / DA / DAL 3