D-Link DCS-4712E Guia De Instalacion página 4

Cable Interfaces
1
2
3
Figure 3: Cable Interfaces
# Feature
RJ-45 connector for Ethernet. Can
Ethernet
1 also be used to power the camera
Jack
using Power over Ethernet (PoE)
Power Connects to an optional 12 V / 1.5 A
2
Connector power adapter (not included)
Press and hold for more than five
Reset
3 seconds, then release to perform
Button
a factory reset.
Table 3: Cable Interface Descriptions
DCS-4712E/DCS-4714E Rear Panel
Interfaces
1
Figure 4: DCS-4712E/DCS-4714E
Rear Panel Interfaces
# Feature
1 microSD Slot Slot for a microSD card.
Table 4: DCS-4712E/DCS-4714E Rear
Panel Interface Descriptions
2
Description
Description
DCS-4718E Bottom Panel Interfaces
1
Figure 5: DCS-4718E Bottom Panel Interfaces
# Feature
microSD Slot for a microSD card.
1
Slot
Table 5: DCS-4718E Bottom Panel
Interface Descriptions
Management Options
To configure and manage your camera, it
is recommended that you download the
associated Setup Wizard and the D-ViewCam
software suite, both of which are available from
the D-Link website.
Installing the Setup Wizard
1. Open a web browser, navigate to
dlink.com/support/, and select your
region.
2. On the next screen, enter the model
number of your camera in the search bar
and click Search. Click the picture of your
camera. On the product page, click the
Download button next to Setup Wizard.
3. Once the executable file has finished
downloading, click it and follow the
instructions to install the Setup Wizard.
Quick Installation Guide
Description