Honeywell HHF550 Serie Manual De Instrucciones página 4

OPERATION
Model HHF565 Series – Digital TurboForce® Heater Operation
Turn heater on by pressing the Power Button ( ).
The Power Indicator will illuminate and the heater
will start in the Low ( ) heat level setting (Fig. 4).
This heater has two operational modes, which can be
chosen using the red switch on the back of the unit
(Fig. 3):
Continuous heating ( ) – heater will run until it
is manually shut off.
Auto-Off ( ) mode - heater will automatically shut
off after 8 hours each time that you use the heater.
Fig. 3
This built-in feature helps ensure that the heater is not
accidentally left on for an extended period of time.
NOTE: See the SafeGuard® Auto-Off Feature section for more information on this feature.
This heater comes pre-set from the factory with the Auto-Off mode engaged. When the unit is turned on,
the Auto-Off icon ( ) will be illuminated on the top of the controls. All features are functional while operating in
the Auto-Off mode.
Should you NOT want the heater to automatically shut off after 8 hours, switch to Continuous heating by simply
pressing the red switch on the back of the unit. Once selected, the Continuous heat icon ( ) will illuminate on the
top of the control panel.
To select a Heat Setting, press ( ):
1. For Low ( ), this setting uses 750 watts of power
2. For High ( ), this setting uses 1500 watts of power
NOTE: The Low ( ) setting does not require as much electricity to operate. It is more energy efficient and may
be a better option if you are concerned about saving energy.
To use the Fan only (no heat), press the Fan button ( ).
To set the thermostat, continue to press the Heat Level button ( ) until Auto is illuminated. There are 4 pre-set
comfort settings from which to choose: 65°, 70°, 75°, 80°. Continue to press the Heat Level button to select your
desired room temperature setting. The heater will operate at HIGH heat in order to reach this desired temperature.
NOTE: If the Current Temperature is higher than your Desired Temperature, the heater will be off until the room
temperature falls below your desired temperature.
To set the Timer, press the ( ) button to select 1, 2, 4, or 6 hour setting. The heater will run for that chosen period
in the selected mode and automatically shut off after the desired time has passed.
Fig. 4
Fan Level
Heat Levels
Timer Button
Oscillation
60º 90º 120º
Auto Heat
Heat Temperature
Fan Button
SafeGuard® Auto Shut-Off
Power Button
4