1.6 AdjusTing The dv-28k for use
The DV-28K is now ready for use; we only have
to adjust the time.
• Remove the plastic cap of the time switch.
On the right side of the clock you will find a
3-position switch.
1
= Continue 'ON'
0 = Everything 'OFF'
= The DV-28K switches at the set times.
• Put the 3-position switch on the clock (
• Now we have to determine when the DV-28K
needs to be switched 'ON' and 'OFF'.
• Therefore, the pins that are around the clock
need to be pushed out.
Are the pins pushed INWARD: The clock will
switch 'OFF'
Are the pins pushed OUTWARD: The clock will
switch 'ON'
• To have the timer switch between 2 times (the
'ON' time, and the 'OFF' time), ALL the pins
between those 2 times need to be pushed out.
• The shortest switch position of the clock is
15 minutes.
• When you have determined the 'ON' and
'OFF' times, turn the clock slowly (manually)
clockwise to make sure everything is correct.
• If you are sure that everything switches at the
right time, the DV-28K is ready for use.
8
DV-28K Binnenwerk PMS.indd 6
Manual DV‑28K
• The correct operation of the DV-28K is only
• Although it is possible to install the DV-28K
• Before installing the DV-28K, the voltage
)
• This guide should only be used for the
• DAVIN
• To qualify for this warranty, you are required
• If changes are made to DAVIN
• The DAVIN
• Neither the manufacturer, nor the importer,
1.7 for Your sAfeTY
guaranteed, if you observe this manual.
yourself, we recommend to have this done by
a certified installer.
MUST be taken off the power point (Check
this!)
DV-28K.
products are covered by a 1-year
®
warranty.
to return the DV-28K to the point of sale.
without the express and written prior
permission of the manufacturer, the warranty
will become void.
warranty will also become void
®
with improper installation of the DV-28K.
nor the retailers of the DV-28K are liable for
damages arising from the use of the DV-28K.
SERVICE NUMBER / HELPDESK:
+31 (0)6 – 14 813 447
products
®
16-10-2012 10:03:56
1
E
q
6
1
D
C
P
P
G
1