For Your Safety - Davin DV Serie Manual

You should now proceed to connect the electrical
ballast fitting to the DV switchbox.
Please read the installation manual for the
electrical ballast carefully prior to doing so, to
ensure that it is connected properly.
If the electrical ballast has been properly
connected, it will have an earthed (230V AC)
power cable.
Insert the plug of the power cable for the
electrical ballast into the built-in power outlet
(socket) on the side of the DV switchbox.
You have now connected the electrical ballast to
the DV switchbox.
1.5 CONFIGURING THE DV SWITCHBOX FOR
USE
Now the DV switchbox has been connected, only
the analogue timer switch needs setting.
• Remove the plastic cap from the timer switch
• On the right of the timer switch, you will find a
3-way switch
1 = Continuously ON
O = Everything off
= The DV switchbox will switch at the
configured times
• Turn the 3-way switch to the clock
• You must now specify when the DV switchbox
should be switched 'ON' and 'OFF'
• In order to do this, the small pins located
around the timer switch must be pushed
outwards
If the pins are IN; The timer switch will switch
'OFF'
If the pins are OUT; The timer switch will
switch 'ON'
• To have the timer switch between 2 times
(the 'ON' time and 'OFF' time), ALL of the
pins between those 2 times must be pushed
outwards
• The minimum switch interval of the timer
switch 15 minutes
• When you have set the 'ON' and 'OFF" times,
8
DV250W_DV400W_DV600W_DV1000W_Binnenwerk.indd 6
All manuals and user guides at all-guides.com
Manual DV - 250W/DV - 400W/
DV - 600W/DV - 1000W
turn the timer switch (manually) slowly
clockwise to make sure everything is correct
• The DV switchbox will be ready for use once
you are convinced that everything switches on
and off at the correct time
1.6

FOR YOUR SAFETY

• The DV switchbox is only guaranteed to
function correctly when the instructions in this
manual have been followed
• Although it is possible for you to install the DV
switchbox yourself, we advise that you have it
installed by a certified installer
• The 230V AC supply voltage MUST be
disconnected from the power outlet prior to
installation of the DV switchbox (check this!)
• This manual is intended solely for use with
one of the DV switchbox models
• DAVIN products come with a 1-year
®
manufacturer's warranty
• In order to qualify for this warranty, you
must return the DV switchbox to the place of
purchase
• Any modification of DAVIN
the prior, express written permission of the
manufacturer shall render the warranty void
• The DAVIN warranty will lapse in the event
®
that the DV switchbox has not been installed
incorrectly
• Neither the manufacturer, the importer, nor
the retailers of the DV switchbox can be help
liable for damages arising as a result of use of
the DV switchbox
SERVICE NUMBER / HELPDESK:
+31 (0)6 – 14 813 447
products without
®
21-12-2011 22:43:38