Sanremo TORINO SAP Libro De Instrucciones página 29

ENGLISH
Insert the filter holder (E) in its seat (F) by turning it anticlockwise. Select the type of delivery required on the keypad (M):
M1=One short/standard coffee.
M2=One standard/long coffee.
M1=Two short/standard coffees.
M4=Two standard/long coffees.
M5=Electronic settings button or continuous manual delivery.
Before use, the operator must always check the indicator (L) to make sure that the level of water in the boiler is above the minimum level.
a) To access this phase keep the button M5 on the first pushbutton panel on the left pressed for over 5 seconds. The indicator lights of the buttons
M5 start to blink continuously. Select the caption corresponding to the amount required and press to dispense. The indicator light of button
M5 and that of the selected caption remain lit. When the required amount has been dispensed, press the selected dispensing button again so
that the control unit stores the data. Repeat the above procedure for all 4 dispensing buttons on the pushbutton panel. A dispensed quantity
may also be set for the hot water button (M6) by repeating the above procedure. Upon completion of the procedure, the remaining groups will
automatically use the stored quantity. The other groups may, however, be programmed independently by repeating the same procedure as
above after having programmed the first group on the left.
b) There are 2 safety systems inside the control unit designed to protect the electronic system and the various parts of the appliance. If, upon
pressing a dispensing button, the corresponding indicator light starts blinking, this indicates a malfunction in the electronic system or lack of
water. For safety reasons, the dispensing of water stops after 4 minutes and in any case after 4 litres of water.
TORINO SED
c) The electronics also offers the possibility of reproducing the pre-brewing effect by wetting the coffee for 0.6 seconds and then
stopping the subsequent brewing from starting for 1.2 seconds. This option is only applicable for single shots of coffee.
Spout assembly filter:
damaged, worn or clogged, they should be replaced.
Drip tray and grid
:
the drip tray and grid should be removed frequently and coffee residues cleaned away.
Water softener: the softener should be periodically regenerated according to the manufacturer's directions given in the instruction booklet.
External housing:
the external housing and the steel parts should be cleaned with sponges and soft cloths to avoid scratching. Only use
detergents that do not contain abrasive powders or solvents and do not use steel wool.
when using the appliance it is recommended that the various instruments be kept under control, checking that they are in the
WARNINGS:
previously indicated normal working conditions.
When the appliance has been left unused for a number of days, or every 2/3 months during normal use, to clean the internal circuits more efficiently,
it is good practice to fill the boiler a number of times and deliver simple water and coffee to be thrown away.
The user must check that this is not due to:
- power failure or blackout.
- lack of mains water supply or no water inside the boiler.
For any other causes, contact a qualified SANREMO After-Sales Service Centre.
BEFORE CARRYING OUT ANY WORk INSIDE THE APPLIANCE OR REMOVING ANY PART OF THE HOUSING, ALWAYS DISCONNECT FROM THE
ELECTRICITY SUPPLY.
Every purchased appliance (keep the receipt, invoice and delivery note) is covered by a statutory guarantee. This warranty envisages the replacement
free of charge of parts that are shown to the service centre or manufacturer's satisfaction to be defective due to faulty materials or workmanship
and providing that the appliance has not been misused or tampered with by unauthorised persons or persons using incorrect components or
techniques.
Any defective part shall be returned to the manufacturer.
NOTE: never activate the pump without water. Excessive heat will damage the pump and
The appliance must not be cleaned using a water jet.
Do not put the appliance in water.
The appliance must not be positioned near to any source of heat.
The appliance is unsuitable for outdoor installation.
Children must be supervised to make sure they do not play with the appliance.
The appliance must be installed in places where its use and maintenance is limited to qualified persons only.
Access to the service area is limited to persons with knowledge and practical experience of the appliance, particularly as regards safety and
hygiene aspects.
COFFEE DELIVERY TORINO SED MODEL
DISPENSER PROGRAMMING
after having dispensed the last cup of coffee, the filter and filter holder must be washed with water. If they are
APPLIANCE FAILURE
CLEANING
WARRANTY
no warranty replacement is granted in that case.
WARNINGS
28