Rogue R2X Spot QRG
About This Guide
Disclaimer
Safety Notes
Contact
What Is
Included
RDM (Remote
Device
Management)
The Rogue R2X Spot Quick Reference Guide (QRG) has basic product
information such as connection, mounting, menu options, and DMX values.
Download the User Manual from
The information and specifications contained in this QRG are subject to change
without notice.
·
DO NOT open this product. It contains no user-serviceable parts.
·
DO NOT look at the light source when the product is on.
·
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
·
CAUTION: When transferring product from extreme temperature
environments, (e.g. cold truck to warm humid ballroom) condensation may
form on the internal electronics of the product. To avoid causing a failure,
allow product to fully acclimate to the surrounding environment before
connecting it to power.
·
CAUTION: This product's housing may be hot when lights are operating.
·
Mount this product in a location with adequate ventilation, at least
20 in (50 cm) from adjacent surfaces.
·
DO NOT leave any flammable material within 50 cm of this product while
operating or connected to power.
·
USE a safety cable when mounting this product overhead.
·
DO NOT operate this product outdoors or in any location where dust,
excessive heat, water, or humidity may affect it. (IP20)
·
DO NOT operate this product if the housing, lenses, or cables appear
damaged.
·
DO NOT connect this product to a dimmer or rheostat.
·
ONLY connect this product to a grounded and protected circuit.
·
ONLY use the mounting brackets or the handles to carry this product. Do not
carry by the moving head.
·
In the event of a serious operating problem, stop using immediately.
·
The maximum ambient temperature is 113 °F (45 °C). Do not operate this
product at higher temperatures.
Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux, contact your
distributor to request support or return a product. From inside the U.S., UK,
Ireland, Mexico, or Benelux, use the information in
QRG.
·
Rogue R2X Spot
·
Neutrik® powerCON® power cord
·
2 Omega brackets with mounting hardware
Remote Device Management, or RDM, is a standard for allowing DMX-enabled
devices to communicate bi-directionally along existing DMX cabling. Check the
DMX controller's User Manual or with the manufacturer as not all DMX
controllers have this capability. The Rogue R2X Spot supports RDM protocol that
allows feedback to make changes to menu map options. Download the User
Manual from
www.chauvetprofessional.com
www.chauvetprofessional.com
for more details.
2
for more details.
Contact Us
at the end of this
·
Warranty Card
·
Quick Reference Guide
EN