General Information; Safety Precautions - Palazzetti ECOFIRE AIR SLIM 7 Manual De Instrucciones

6 INSTALLATION

6.1 GENERAL INFORMATION

The following paragraphs provide instructions that
must be complied with in order to ensure maximum
ef ciency of the product purchased.
The following instructions are however subordinate
to compliance with any national, regional and local
laws and standards in force in the country where
the product is installed.
The stove must be installed by quali ed personnel
in compliance with EN 10683.

6.2 SAFETY PRECAUTIONS

Responsibility for work carried out in the place
where the stove is installed lies with the user;
the user is also responsible for making sure the
installation checks are completed.
The user must abide by all local, national and
European safety requirements.
The appliance must be installed on oors with a
suitable load-bearing capacity.
The stove assembly and dismantling instructions
are reserved exclusively for specialist technicians.
Users should always contact our service centre
to request work to be performed by quali ed
technicians.
Before having work performed by other technical
personnel verify
competence. Before starting to assemble or
dismantle the stove, the installer must heed the
safety precautions required by law, speci cally:
A) do not work in adverse conditions;
B) always be in a t mental-physical state for working
and make sure that personal protective
equipment is in perfectly working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
26
their effective technical
COD. 00477 7260 - 09/2018 - Palazzetti - PN - Italy
6.3 STOVE INSTALLATION SITE
Figure 5.2 shows the minimum clearance there should be
around the stove in relation to materials and ammable
objects.
A) Adjacent wall.
B) Rear wall.
C) Side wall.
D) Floor protection.
Protect all structures that may catch re if exposed
to excessive heat.
Floors made from ammable materials such as:
wood, parquet, linoleum, laminates or carpets
must be protected by a suitably-sized reproof
base underneath stove. Such base may be made
from steel, slate, glass or stone and must cover
the oor in the part underneath the stove and the
ue attachment, and must extend at least 50 cm
at the front.
The manufacturer declines all liability for any
alterations to the characteristics of the material
making up the
base.
Any elements made from wood (e.g. beams) or
other combustible material located near the stove
should be protected with reproof material.
Leave enough clearance for maintenance work, and
at least 20 cm on the left side to access the power
switch located on the rear of the stove.
Make sure the minimum distance from ammable
materials is observed, as shown on the pipes used
to make up the ue or chimney.
oor underneath the protective
Fig. 5.2