User Maintenance - Andis G-1 Instrucciones De Uso Y Cuidado

OPERATING INSTRUCTIONS
Before starting trimmer remove blade guard (some models may not have a blade
guard). Plug cord into electrical outlet, operate at 230 volt, 50 cycle AC electrical
current or as noted on the unit. To start trimmer move switch button to on
position, to stop, move switch button back to original position. After using your
Andis trimmer, rewrap cord and store in a safe place.
Some units come with a fixed plug; some units come with a universal
input power adapter that uses detachable plugs. For these units refer
to the instructions below. For those units with a fixed plug, there is no
need to attach a plug adapter.
UNIVERSAL INPUT POWER ADAPTER
This unit is equipped with a universal input power adapter (Figure A).
Interchangeable input plugs are included for use in most countries around the
world (plugs will vary by unit):
Europe: generally used in Continental Europe (Figure B)
SAA: generally used in Australia (Figure C)
UK: generally used in Great Britain (Figure D)
Brazil: generally used in Brazil (Figure E)
US: generally used in United States (Figure F)
INSERTING INPUT PLUG
1. Unplug power adapter from wall outlet.
2. Insert tabs on top of plug into slots on power adapter (Figure G).
3. Push lower half of plug towards power adapter until it snaps into place.
REMOVING INPUT PLUG
1. Unplug power adapter from wall outlet.
2. Push up on tab on bottom of plug until plug releases from adapter.
A B
EUROPE
F G
US
4
C D
SAA UK BRAZIL
H I

USER MAINTENANCE

Cleaning and user maintenance shall not be made
by children without supervision.
The internal mechanism of your motor trimmer has been permanently lubricated
by the factory. Other than the recommended maintenance described in this
manual, no other maintenance should be performed, except by Andis Company,
or an Andis authorized service station.
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
Blades should be oiled before, during, and after each use. If your trimmer
blades leave streaks or slows down, it's a sure sign blades need oil. The trimmer
should be held in a position shown in Figure H to prevent oil from getting into
motor. Place a few drops of Andis Clipper Oil on the front and side of the cutter
blades (Figure I). Wipe excess oil off blades with a soft dry cloth. Spray lubricants
contain insufficient oil for good lubrication, but are an excellent trimmer coolant.
Always replace broken or nicked blades to prevent injury. You can clean the
excess hair from your blades by using a small brush or worn out tooth brush. To
clean the blades we suggest to immerse the blades only into a shallow pan of
Andis Blade Care Plus, while the trimmer is running. Any excess hair and dirt that
has accumulated between the blades should come out. After cleaning, turn your
trimmer off and dry blades with a soft, dry cloth and start clipping again.
FACTORY REPAIR SERVICE
When the blades of your Andis trimmer become dull after repeated use, it is
advised to purchase a new set of blades available through your Andis supplier or
through an Andis authorized service station.
E
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm
to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
OIL
CAUTION: Never handle your Andis trimmer while you are operating a water
faucet and never hold your trimmer under a water faucet or in water. There is
danger of electrical shock and damage to your clipper. ANDIS COMPANY will
not be responsible in case of injury due to this carelessness.
5