Agitator Assembly - KENMORE ELITE 116.21814 Manual De Uso Y Cuidado

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um cleaner, the agitator must be cleaned
every time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(useddaily)
MODERATE - every month
(used2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
PowerMate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.
AGITATOR ASSEMBLY
-End Cap Belt Path_
TO REPLACE BELT
1. Install new belt over motor drive, then
over belt path.
NOTE: See PARTSAND FEATURESfor Belt
number. (page 5)
Motor Shaft
Path
itator End Cap
2. Place agitator
assembly back
into PowerMate.
3. Reinstall agitator
cover by placing
the tabs on the
agitator cover into
the slots in the
base. Reinstall two
(2) screws.
4. Line up front
of cover and
base. Rest
cover on front
edge of base
as shown.
5. Rotate cover
back. Press
cover firmly
until side and
rear latches snap into place.
NOTE: Make sure there is no gap between
the cover and base.
6. Turn PowerMateupside down and
replace three (3) cover screws.
7. Insert floor brush
into PowerMate
until floor brush
locks into place.
- 23 -