Agitator Assembly - KENMORE ELITE 125.21814610 Manual De Uso

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning HèFLHQF\
high and to prevent damage to your vacu-
um cleaner, the agitator must be cleaned
every time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
IMPORTANT
TXUQ Rç DQG XQSOXJ YDFXXP FOHDQHU Irom
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
®
PowerMate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.

AGITATOR ASSEMBLY

End Cap
Brush Unit
TO REPLACE BELT
1. Install new belt over motor shaft, then
over belt path.
NOTE: See PARTS AND FEATURES for Belt
number (page 5).
End Cap
Agitator
Clean Agitator
every week
every month
every 2 months
Belt Path
End Cap
Motor Shaft
Belt Path
- 23 -
2. Place agitator
assembly back
®
into PowerMate .
Tab
Slot
4. Line up front
of cover and
base. Rest
cover on front
edge of base
as shown.
5. Rotate cover
back. Press
cover oUPO\
until side and
rear latches snap into place.
NOTE: Make sure there is no gap between
the cover and base.
®
6. Turn PowerMate upside down and replace
the three (3) screws that secure the cover to
the base.
7. Insert pRRU brush
®
into PowerMate
until pRRU brush
locks into place.
3. Reinstall agitator
cover by placing
the tabs on the
agitator cover into
the slots in the
base. Reinstall two
(2) screws.