Atlantic SQUARE O’PRO S4 Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
Check that the pipes and the door seal under the caver are not leaking. If there are any leaks tighten gently. Check that the water safety devices are working and fill the appliance.
Switch on the appliance. After 5 to 20 minutes according to the capacity of the appliance, water should start dripping from the drain outlet. This is normal and results from the
expansion of the water. Check that joints and seals are watertight. In the course of heating up, shielded water heaters may make a boiling noise ; this is normal and does not indicate
any fault with the appliance.
To avoid the development of bacteria (legionella...) ensure that a temperature of 60°C is reached every day. The thermostat is set at the factory at (65°C+- 5°C). IMPORTANT: If
steam or boiling water emerges continuously from the drain plug or drain tap, switch off the electricity and call a professional.
MAINTENANCE
User maintenance: operate the drain valve on the safety device once a month. If this is not done, damage may be caused and the guarantee invalidated.
GB
Maintenance by a qualified person:
a) Remove the scale sludge. Do not scrape or chip at lime scale deposited on the casing because this may damage the lining.
b) Change the magnesium anode every 2 years or when its diameter is less than 10 mm. Changing the shielded heating element or the anode requires the water heater to be drained
and the seal changed. Switch off the power and cold water and open the hot water taps before carrying out these operations. Refit the heating element and tighten the screws gently
(opposite screws in sequence), check for leaks the next day and tighten if required.
REPLACEABLE PARTS: the thermostat, seals, heating element, boiler shell, the indicator light, the magnesium anode, the connection cable. The guarantee requires genuine
manufacturer's parts to be used.
SCOPE OF THE GUARANTEE
The water heater must be installed, used and maintained according to best practice and conform to the standards in force in the country in which it is installed and to the instructions
contained in this document. In the European Union this appliance is covered by the statutory guarantee accorded to consumers in accordance with directive 1999/44/CE. This
guarantee comes into force when the appliance is delivered to the consumer. In addition to the legal guarantee, certain items are covered by an extra guarantee relating only to the
free exchange of the tank and of components accepted as defective. It does not include the cost of replacement or carriage. Refer to the table below. This commercial guarantee
does not affect your statutory rights. It applies within the country where the product was acquired, provided it is also installed in the same country. The dealer must be informed of
any damage before the product is exchanged under guarantee and the appliance will remain available for inspection by experts from the insurance company and the manufacturer.
Range
Statutory
Extra commercial guarantee on tanks and the
sleeve for "STEATITE" except for electrical
components
To claim under guarantee, contact your installer or dealer. If necessary, contact: ATL INTERNATIONAL Tel.:(33)146836000, Fax (33)146836001 58 av Gén. Leclerc 92340
Bourg-la-Reine (France) who will inform you of what you should do. The guarantee applies only to examine products which are accepted as faulty by the company underwriting the
guarantee. It is essential that products should be retained for inspection by them. Exclusions: Wear parts: magnesium anodes....Equipment which cannot be assessed (access difficult
for repair, maintenance or assessment). Equipment exposed to abnormal environmental conditions: frost, bad weather, water which is abnormally aggressive or outside drinking
standards, electrical supply with large spikes. Equipment installed without observing current standards in the country of installation: the absence or incorrect fitting of safety devices,
abnormal corrosion due to incorrect water fitments (iron/copper contact), incorrect earthing, inadequate cable thickness, non observance of the connection drawings shown in these
instructions. Equipment not maintained in accordance with these instructions. Repairs or replacement of parts or components in the equipment not carried out or authorised by the
company responsible for the guarantee. Changing a component does not extend the life of the guarantee.
14
CAUTION: To reduce the risk of excessive pressures and temperatures in this water heater, install temperature and pressure protective equipment supplied with the water heater
(pressure relief devices). Install the valve into an opening provided for this purpose in the water heater, and orient it or provide tubing so that any discharge from the valve will exit
only within 15cm above or at any distance below the structural floor and cannot contact any live electrical part. The discharge opening must not block or reduce in size under any
circumstances.
The products illustrated in these instructions may be modified at any time to reflect changes in manufacture and current norms. Equipment conforms to electromagnetic directives 2004/108/CEE and low voltage 2006/95/CEE.
SQUARE O'PRO
2 years all parts
+ 1 year (For Ireland : + 0 year)
SQUARE CERAMIC
2 years all parts
+ 3
years (For Ireland : + 0 year)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Square o’pro s3Square ceramic s3Square ceramic s4 ceramic

Tabla de contenido