Whittier Wood 589Wb Instrucciones Para Armar página 9

J
Figure shows installing
skirt on right door.
FIG. 8
8) Attach the Door Skirt (ZQ) to either the left or right door, depending on which side you would like to
open fi rst. With the door laying face down, measure in 5/8" from the outside edge and draw a light
line. Lay the Door Skirt (ZQ) on the line, fl ush with the bottom edge of the door. Attach the Skirt to
the door with four #6 x 5/8" Philtruss Screws (ZU) through the predrilled holes in the skirt. See FIG-
URE 8.
With the unit standing upright, attach the doors to the sides with #6 x 5/8" Undercut (type 17)
Screws (Z). The pre-punched holes in the Sides will show the location of the uppermost hole in the
upper hinge and the lowermost hole in the lower hinge. Insert the screws in the middle of the elon-
gated hinge holes to allow for adjustment if necessary. Do not insert screws in the round screw holes
until after fi nal adjustments have been made. Open and close doors to check for proper alignment.
If some adjustment is necessary, loosen the screws and move the doors. See FIGURE 8A.
Attach the Magnetic Catch Plates (X) to the upper inside corner of the doors where they will make
contact with the magnetic catch. See FIGURE 8B.
5/8" ZU
ZU
ZQ
ZU
ZU
Z
J
X
J
W
FIG. 8A
Z
J
X
FIG. 8B
Z
Rev. 9/07 — 589Wb — Page 9