Safety Precautions - VESTEL AC22 Serie Guia De Instalacion

SAFETY PRECAUTIONS

Warnings
1) WARNING: Danger of electrical shock or injury. Turn OFF power at AC mains side or
load center before connecting the electrical supply of the EV charger.
2) On AC mains side of the Vestel EV charger, below Circuit Braker, Ground Fault Circuit
Protector and AC mains cable combinations must be used according to the models.
AC22 Series
Electrical Infrastructure Requirement
Required Circuit Breaker on AC Mains
Required Ground Fault Protector on AC Mains
Required AC Mains Cable
Vehicle charge cable
AC11 Series
Electrical Infrastructure Requirement
Required Circuit Breaker on AC Mains
Required Ground Fault Protector on AC Mains
Required AC Mains Cable
Vehicle charge cable
WALL MOUNTING WARNINGS
1) Read the instructions before mounting your charging station on the wall.
2) Do not install the charging station on a ceiling or inclined wall.
3) Do not install the charging station near heating devices.
3) Use the specifed wall mounting screws and other accessories.
4) This unit is rated for indoor or outdoor installation.
5) If this unit is mounted outdoors, the hardware for connecting the conduits to the unit must be rated for
outdoor installation and be installed properly to maintain the proper IP rating on the unit.
CAUTION
RISK OF ELECTRIC SHOCK
CAUTION :
VESTEL EV CHARGER MUST BE INSTALLED ONLY
BY A LICENSED AND EXPERIENCED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE LOCAL AND
NATIONAL ELECTRICAL CODES AND STANDARDS.
English - 1 -
400VAC 50/60 Hz - 3-phase 32A
4P-40A MCB Type-C
40A - 30mA RCCB Type-B
5 x 6mm2 (< 50m)
Outer Dimension: Ø 15-21 mm
Type 2 socket compatible on charging station side
400VAC 50/60 Hz - 3-phase 16A
4P-20A MCB Type-C
20A - 30mA RCCB Type-B
5 x 4mm2 (< 50m)
Outer Dimension: Ø 15-21 mm
Type 2 socket compatible on charging station side