Electronic Steam Wand; Sensibility; Grinding Notice; Adjusting Parameters Of The Grinding Notice - Expobar G-10 Manual De Mantenimiento

7.9. Electronic Steam wand

If the machine is equipped with an electronically-controlled steam wand (no
manual steam tap), this option adjusts which keypad will control it. If the
machine has not one, this option must be set to 0. Adjust the number by
pressing (+) (1 short espresso) or (-) (1 long espresso). To accept the setting
and proceed to the next menu, press the continuous brewing button.
Once selected which keypad will control the electronic steam wand, the time that steam is coming out from it
(the dose) can be adjusted as explained for the other buttons in the User Manual.
If your electronic steam wand, has a temperature probe (as per customer's request), when adjusting the dose
as explained in the User Manual, what will be controlled will not be the time steaming, but the temperature of
the liquid being heated up. This means, that once adjusted the electronic Steam wand with temperature probe,
the machine will steam up the liquids stopping always at the very same temperature measured on the liquid
being heated, independently from the volume of liquid being heated up.

7.10. Sensibility

Here it can be adjusted the detection sensibility of the level probes of the
boiler. Normally it is not needed to modify it from the "medium", but in some
cases (very pure water, this is water with very low level of dissolved salts), it
will be needed to select High sensibility; and vice versa.
By default this sensibility will be set to "Med", and generally it is not needed to
modify it.
To increase sensibility, press (+)(one short espresso), to decrease it (-)(one long espresso).
To accept the setting and proceed to the next menu, press the continuous button.

7.11. Grinding notice

This setting enables or disables the brewing monitor. This function analyzes
the output flow when brewing, and depending on it, advises if the grinded
coffee is too thin or too coarse. If the brewing flowrate was between limits, it
will display "Ok" at the end of the brewing process.
To enable it, press (+)(one short espresso) to disable it (-)(one long
espresso).
To accept the setting and proceed to the next menu, press the continuous button

7.12. Adjusting parameters of the grinding notice

If in the previous section the grinding notice was enabled, in this menu, its parameters can be adjusted. If it was
disabled, this menu will not appear.
Here it is adjusted the minimum flow rate that will be considered as inferior
limit of a good brewing flowrate. To increase this value, press (+)(one short
espresso), to decrease it (-)(one long espresso).
To accept the setting and proceed to the next menu, press the continuous
button.
Here it is adjusted the maximum flow rate that will be considered as superior
limit of a good brewing flowrate. To increase this value, press (+)(one short
espresso), to decrease it (-)(one long espresso).To accept the setting and
proceed to the next menu, press the continuous button.

7.13. Sequential flashing of lights of touchpads

The blinking of the keypads lights can be enabled by pressing (+)(one short
espresso) and disabled by pressing (-)(one long espresso).
To accept the setting and proceed to the next menu, press the continuous
button.
• Technical programming on machines with display
11
Steam Boiler Gr.
N
Sensibilidad
Baja / Media / Alta
Grinding Notice
Enabled/Disabled
Grinding Notice
Min. X.X cc/sec
Grinding Notice
Max. X.X cc/sec
Rotation Leds
Enabled/Disabled
English