Arrow T50ACD Manual Del Usuario página 4

SPECIFIC WARNINGS & SAFETY RULES
TOOL SAFETY WARNINGS
Always assume that the tool contains fasteners.
Careless handling of the tool can result in unexpected
firing of fasteners and personal injury.
Do not point the tool towards yourself or anyone
nearby. Unexpected triggering will discharge the
fastener, and can cause an injury.
Do not actuate the tool unless the tool is placed firmly
against the workpiece. If the tool is not in contact with
the workpiece, the fastener may be deflected away from
your target.
Disconnect the tool from the power source when the
fastener jams in the tool. While removing a jammed
fastener, the tool may be accidentally activated if it is
plugged in.
Use caution while removing a jammed fastener. Point the
tool away from self and others. The mechanism may be
under compression and the fastener may be forcefully
discharged while attempting to free a jammed condition.
Do not use this tool for fastening electrical cables. It is not
designed for electric cable installation and may damage
the insulation of electric cables, thereby causing electric
shock or fire hazards.
SPECIFIC SAFETY RULES
1. Hold tool by insulated gripping surfaces when
performing an operation where the tool may
contact hidden wiring or its own cord. Contact
with a "live" wire will also make exposed metal parts of
the tool "live" and shock the operator.
6
2. Know your power tool. Read operator's manual
carefully. Learn its applications and limitations, as well as
the specific potential hazards related to this tool. Following
this rule will reduce the risk of electric shock, fire, or
serious injury.
3. Always wear safety glasses with side shields.
Everyday glasses have only impact resistant lenses.
They are NOT safety glasses. Following this rule will
reduce the risk of eye injury.
4. Protect your hearing. Wear hearing protection during
extended periods of operation. Following this rule will
reduce the risk of serious personal injury.
5. Protect your lungs. Wear a face or dust mask if
the operation is dusty. Following this rule will reduce
the risk of serious personal injury.
6. Do not attempt to alter the tool. Your T50ACD
a tested cycling time. It is designed to perform adequately
at this rate. Any unauthorized alteration
and/or use of unauthorized replacement parts is misuse,
which could result in a hazardous condition causing
possible serious personal injury. For best performance,
use only Arrow replacement parts.
7. Use only ARROW replacement parts.
®
8. The tool should always be supplied via a
residual current device with a rated residual
current of 20 mA or less.
FUNCTIONAL DESCRIPTION
V ...................... Volts
A ...................... Amperes
Hz .................... Hertz
- ...................... Alternating Current
Air vents
™ has
Trigger
Motor Drive
Technology
DEFINITION OF SYMBOLS USED ON TOOL
& FUNCTIONAL DESCRIPTION
Obey all safety messages that follow this
symbol to avoid possible injury or death.
To avoid loss of hearing, always wear
ear protection when operating the tool.
Contact safety.
Always wear safety glasses
when operating the tool.
Class II Tool
Power cord
On/off switch
Quick release
magazine
7