Grease Filter Removal - Charcoal Filter Installation; Connecting The Hood To Power Supply; Electrical Connection - De Dietrich DHD7561B Manual De Utilización

GREASE FILTER REMOVAL , ACTIVA-
TED CHARCOAL FILTER INSTALLA-
TION
Grease filters and charcoal filters remo-
ving and fitting operations shall be carri-
ed out with the downdraft open . To open
the downdraft, push the key
Remove the grease filters to reach the
charcoal filters . Charcoal filters shall be
replaced (fig. 10-11) accordingly to the
actual use of the Downdraft, in any case
at least once every 6 months.
CONNECTING THE HOOD TO PO-
WER SUPPLY
This appliance is equip-
ped with a H05 VVF with
3 x 0,75 mm2 conductors
(neutral, phase and ground)
power cord. It shall be con-
nected to a 220V – 240 V
electrical mono-phase net-
work through a CEI 60083
approved power socket,
which shall be accessible
after installation, in com-
pliance with installation
regulations. We hereby de-
cline any liability in case
of accidents due to failure
to connect the hood to the
ground or incorrect ground
connection. The fuse to be
used shall be 10 or 16A. In
case of damages to the po-
wer cord, please call the
after-sale service in order to
avoid any kind of risk.

ELECTRICAL CONNECTION

This appliance complies with Europe-
an Directives 2006/95/CE (Low Voltage
Directive) and 2004/108/CE (Electroma-
gnetic Compatibility).
The hood shall be disconnected from po-
. wer supply during installation and main-
tenance operations, while fuses shall be
disconnected or removed. Electrical con-
nection shall be completed before fitting
the appliance into the cabinet.
Check that:
- Power is adequate
- Power lines are in good conditions.
- Cables diameter is compliant with in-
stallation regulations.
Caution
In case the hood shows any
anomalies, please disconnect
it or remove the fuse corre-
sponding to the appliance po-
wer disconnecting line.
36