Panasonic AW-PH360L Manual De Operación página 37

Connections
;When the pan/tilt head is to be controlled by the AW-RP400 pan/tilt head control panel
for transmitting composite or component signals (and the WV-CB700A remote control
box is used to control the camera)
10BASE-T (equivalent to UTP
category 5) straight cable
(max. 500 m)
Nominal cross section
2
1.25 mm or more
AC adapter: AW-PS300A
• Use the supplied camera cable to connect the unit with the convertible camera.
• Set controller selection switch SW1 to the right side (RP501), and select the transmission signal
selection setting that supports the analogue/IEEE1394 card.
• Use a 10BASE-T straight cable (UTP category 5) to connect the unit's CONTROL IN IP/RP
connector with the controller's CONTROL OUT TO PAN/TILT HEAD connector.
• Use a coaxial cable (BBC No.PSF1/2M, BELDEN 8281) to connect the unit's VIDEO OUT
connector with the cable compensation unit's Y VIDEO IN connector (when composite signals are
to be transmitted).
• Use a coaxial cable (BBC No.PSF1/2M, BELDEN 8281) to connect the unit's Y OUT connector,
Pr/SDI OUT connector and Pb OUT connector with the cable compensation unit's Y VIDEO IN
connector, PR C IN connector and PB IN connector (when component signals are to be transmitted).
• Use a coaxial cable to connect the cable compensation unit's Y VIDEO IN connector, PR C IN
connector and PB IN connector with the colour monitor's VIDEO input connector or component
input connectors.
• Use the cable supplied with the remote control box to connect the controller's CAMERA
CONTROL IN FROM RCB connector with the remote control box's RCB connector.
• Check that the pan/tilt head and camera can be controlled by the controller.
Camera cable
(supplied)
Cable supplied
with WV-CB700A
Pan/tilt control panel:
AW-RP400
Cable compensation unit:
AW-RC400
Coaxial cable (BBC No.PSF1/2M,
BELDEN 8281, max. 500 m)
- 36 (E) -
Genlock signals must be supplied if
a multiple number of cameras and
pan/tilt heads are to be used.
Remote control box:
WV-CB700A
Coaxial cable
Colour monitor