Axxess AX-HYKIACAM2-6V Instrucciones De Instalación

Installation Instructions for AX-HYKIACAM2-6V
AX-HYKIACAM2-6V
Hyundai / Kia (without NAV)
2014-2017
INTERFACE FEATURES
• Retains the factory back-up camera to an aftermarket radio
• Allows an aftermarket camera to be added to the factory screen
• Includes the AX-CAM6V 12-volt to 6-volt converter
INTERFACE COMPONENTS
• AX-HYKIACAM2-6V harness • AX-CAM6V 12-volt to 6-volt converter
APPLICATIONS
HYUNDAI HYUNDAI (CONT)
Sonata
Elantra * 2017
Tucson
Elantra 2014-2016
Santa Fe 2013-2016
KIA
Santa Fe Sport * 2017
Forte *
Santa Fe Sport 2013-2016
Optima *
* Without 7-inch touchscreen radio
** Without UVO radio
TOOLS REQUIRED
• Wire cutter • Crimping tool • Solder gun • Tape
• Connectors (example: butt connectors, bell caps, etc.)
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator lights
must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
® axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 4/14/17 © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
KIA (CONT)
2015-2016
Optima 2016
2014-2017
Sedona ** 2015-2016
Sorento * 2017
Sportage * 2017
2017
2017
Installation Instructions for AX-HYKIACAM2-6V
Connections to be made
The AX-HYKIACAM2-6V can be connected two different ways
To retain the factory back-up camera to an aftermarket radio:
• Connect the Black wire to chassis ground, and also to the Black wire of the AX-CAM6V.
• Connect the Red wire to the Blue/Red wire of the AX-CAM6V.
• Connect the reverse wire of the aftermarket radio, and the Blue/White wire of the
AX-CAM6V, to a reverse wire.
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the Black wire to the aftermarket cameras ground wire.
• Connect the power wire of the aftermarket camera to accessory power.
• Connect the female Yellow RCA jack to the aftermarket camera.
• Tape off and disregard the following (1) wire, it will not be used in this application: Red.
• Disregard the AX-CAM6V, it will not be used in this application.
Note: If the Blue/Red wire is not populated on the factory side, a reverse wire will need to
be sourced from the vehicle. A 48-inch loose Green/Purple wire is included for this purpose.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
® axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 4/14/17 © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians