Axxess AX-HUB Instrucciones De Instalación

AX-HUB
(to be used along with the Axxess Updater app)
FEATURES
• Allows the ability to update Axxess interfaces from
most mobile devices
• Allows updates from iOS devices
• Allows updates from Android devices
• Freedom to update without a computer
• Must be connected to either a cellular network,
or Wi-Fi hotspot to update
• Allows changes to be made to the ASWC-1 (dual assign, force
radio, reassign buttons)
APPLICATIONS
• Android mobile devices • iOS mobile devices
INTERFACE COMPONENTS
• Axxess hub interface • DC power cable with
cigarette lighter adapter • 4-pin to 4-pin Bootloader update cable
• Micro "B" USB update cable
Axxess Integrate
Installation instructions for AX-HUB
axxessinterfaces.com
Connections to be made
• Connect the DC power cable into
the AX-HUB and then into the
vehicles DC plug.
Note: Depending on the vehicle,
the ignition may need to be on to
provide power to the AX-HUB.
CAUTION!
Metra recommends disconnecting the negative battery terminal before beginning any instal-
lation, unless the vehicle manufacturer recommends against so. Please check with your local Dealership
for more information. All accessories, switches, climate controls panels, and especially air bag indicator
lights must be connected before reconnecting the battery or cycling the ignition. Also, do not remove the
factory radio with the key in the on position, or the vehicle running. It would be best to remove the key
from the ignition and then wait a few seconds before removing the factory radio.
•
metraonline.com
• Connect the USB SYNC cable,
provided with your mobile device, to
the USB port located on the RIGHT
side of the AX-HUB.
(Continued on the next page)
Bootloader 4-pin
cable interface
DC car power input
Mobile device
USB input
Micro USB
input
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION