Aquanex AQU36 Manual Del Propietário página 20

WATER LINE CONNECTION
Connector Assembly
Ensamble del conector
"H" Clip
Sujetador tipo "H"
The bypass assembly connects to the water
system by means of a connector assembly. The
connector is secured to the plumbing and then
inserted into the bypass. A clip is used to hold it
in place.
Figure 10 Connector Assembly
Figura 10 Ensamble del conector
19 • 1/12
Drain Line
Línea de desagüe
IN
HACIA AFUERA
HACIA ADENTRO
Handles in Service
Manijas en posición de servicio
Figure 9 Series 360 Bypass Operation
Figura 9: funcionamiento normal de la derivación de la serie 360
IN
HACIA ADENTRO
OUT
Before inserting the connector:
• Check that all O-rings are in place and not
damaged.
• Lubricate O-rings and sliding surfaces with
100% silicone.
Firmly insert connector into bypass. Press
locking clip into position. Make certain the clip is
fully engaged.
To remove a clip:
1. Turn off water and release water pressure
at the valve.
2. Push the water line connectors into the
bypass and valve. This will help release
O-rings that may have seated in place.
3. Remove the clip by inserting a flat blade
under the top center of the clip and lifting
(prying up).
CAUTION: Do not use pliers to remove a clip.
It is likely the clip will break.
NOTE: Before turning on the water to the valve,
rotate the two handles on the bypass valve 2-3
times. This will help seat O-rings and prevent
leaking.
OUT
HACIA AFUERA
Handles in Bypass
Manijas en posición de desvío