Overflow Line Connection; Salt Line Connection - Aquanex AQU36 Manual Del Propietário

OVERFLOW LINE CONNECTION

In the event of a malfunction, the salt TANK
OVERFLOW will direct "overflow" to the drain
instead of spilling on the floor. This fitting should
be on the side of the cabinet.
To connect the overflow line, locate the hole
on side of tank. Insert overflow fitting into
tank (Figure 13 Overflow Line Connection)
and tighten with plastic thumb nut and gasket.
Attach length of 1/2-inch (1.3-cm) I.D. tubing
(not supplied) to fitting and run to drain. Do not
elevate overflow line higher than overflow fitting.
Do not tie into drain line of control unit. Overflow
line must be a direct, separate line from overflow
fitting to drain, sewer or tub. Allow an air gap as
per drain line instructions.

SALT LINE CONNECTION

The salt line from the brine tube connects to the
valve. Make certain the connections are hand
tightened. Be sure that the salt line is secure
and free from air leaks. Even a small leak may
cause the salt line to drain out, and the softener
will not draw salt from the tank. This may also
introduce air into the valve causing problems
with valve operation.
23 • 1/12
Figure 13 Overflow Line Connection
Figura 13 Conexión del tubo de desbordamiento
Salt Line Connection
Conexión del tubo de sal
Figure 14 Salt Tank Check Valve
and Brine Well Assembly
Figura 14 Ensamble de la válvula de retención del depósito
de sal y del depósito de salmuera
Brine Tube
Tubo de salmuera