Manual Overview; Equipment Installation; General Warnings And Safety Information Electrical; Mechanical - Aquanex AQU36 Manual Del Propietário

MANUAL OVERVIEW

HOW TO USE THIS MANUAL
This installation manual is designed to guide the
installer through the process of installing and
starting softeners featuring the 706 Logix series
controller.
This manual is a reference and will not include
every system installation situation. The person
INSPECTION
Inspect the unit for damage or missing parts. Contact your supplier if any discrepancies exist.

EQUIPMENT INSTALLATION

GENERAL WARNINGS AND SAFETY INFORMATION ELECTRICAL

There are no user-serviceable parts in the AC
adapter, motor, or controller. In the event of a
failure, these should be replaced.
• All electrical connections must be
completed according to local codes.

MECHANICAL

• Do not use petroleum based lubricants
such as vaseline, oils, or hydrocarbon
based lubricants. Use only 100% silicone
lubricants.
• All plastic connections should be hand
tightened. Plumber tape may be used on
connections that do not use an O-ring seal.
Do not use pliers or pipe wrenches.
• All plumbing must be completed according
to local codes.
• Soldering near the drain line should be
done before connecting the drain line to
the valve. Excessive heat will cause interior
damage to the valve.
• Do not use lead-based solder for sweat
solder connections.
7 • 1/12
installing this equipment should have:
• Knowledge in the 706 Logix series
controller and water softener installation
• Knowledge of water conditioning and how
to determine proper control settings
• Basic plumbing skills
• Use only the power AC adapter that is
supplied.
• The power outlet must be grounded.
• To disconnect power, unplug the AC
adapter from its power source.
• Observe drain line requirements.
• The drain line must be a minimum of
1/2-inch diameter. Use 3/4-inch pipe if the
backwash flow rate is greater than 7 gpm
(26.5 Lpm) or the pipe length is greater
than 20 feet (6 m).
• Do not support the weight of the system on
the control valve fittings, plumbing, or the
bypass.
• It is not recommended to use sealants
on the threads. Use plumber tape on the
threads of the 1-inch NPT elbow, the drain
line connections, and other NPT threads.