Display Icons - Levenhuk Blaze D500 Guia Del Usuario

Levenhuk Blaze D500
Digital Spotting Scope
EN
Parts of the digital spotting scope
Focusing wheel
Power on/off
Setup
Up/Exposure increase
Down/Exposure decrease
Photo/Video/Playback
Capture
TV out
MicroSD slot
MicroHDMI out
1
19
11
12
13
14
The kit includes: digital spotting scope, tripod, capture remote control, AC adapter, 8GB
microSD memory card, USB cable, TV cable, pouch, objective lens cap, user manual and
warranty slip.
Digital zoom
DC: charge battery (5V)
USB: output to PC
Charging indicator
Capture remote control unit in
Photo/Video/Playback
Digital zoom
Capture
Playback
1/4" screw hole (not shown)
8
9
10
2 3 4 5 6 7
Never, under any circumstances, look directly at the Sun,
another bright source of light or at a laser through this device, as
this may cause PERMANENT RETINAL DAMAGE and may lead to
BLINDNESS.
Digital spotting scope assembly
Take the digital spotting scope and all the accessories out of the package. Place the
tripod on a stable surface. Insert the screw of the tripod into the 1/4" screw hole on
the body of the digital spotting scope (19) and rotate until the spotting scope is firmly
attached. Do not apply excessive pressure when attaching the digital spotting scope.
Charge the built-in Li-ion battery via USB cable. Insert the microSD card into the slot
(9). Press the Power on/off button (2) and hold it for 3 seconds to turn the device on. The
digital spotting scope is now ready to use.
Note: It is recommended to use the included tripod for indoor observations and a
professional tripod (not included in the kit) for observations outside. The tripod helps to
minimize image shaking.
Caution: Please refer to the specifications table for the correct mains voltage and never
attempt to plug a 110V device into 220V outlet and vice versa without using a converter.
Remember that mains voltage in the U.S. and Canada is 110V and 220–240V in most
European countries.

Display icons

15
16
17
18
Note: Interface icons will be hidden if no key has been pressed and held for 10 seconds.
Using the digital spotting scope
Connection to TV/monitor with HDMI input
1) Connect the digital spotting scope to the TV/monitor by inserting the microHDMI-HDMI
cable into the HDMI input port. Turn on the power of your TV/monitor and select the
HDMI setting.
2) Power the digital spotting scope with the supplied power adapter. If the digital spotting
scope is not already on, turn on the power by pressing the Power on/off button (2), and
Capture an image
Start and stop video recording
Exposure
Length of video that could be captured (based on the current resolution)
Current resolution
MicroSD status icon
Battery status indicator
3