Product Description And Specifications - Bosch HWS Serie Manual Original

OBJ_BUCH-2482-003.book Page 18 Friday, December 9, 2016 12:33 PM
18 | English
 Operate the power tool exclusively with a fitting plug.
The CEE plug must be dimensioned for the nominal current
that the power tool requires (see "Technical Data").
 Plug mounting and connection to the power supply is to
be carried out by a qualified electrician trained in han-
dling high-frequency tool systems.
 Use only original cables! Before each use, check the
power tool, cable and plug for possible damage. Cables
and plugs may not be repaired, but must be exchanged in
order to avoid danger.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
While reading the operating instructions, unfold the graphics
page for the machine and leave it open.
Intended Use
The machine is intended for cutting metal and stone materials
without the use of water.
For cutting with bonded abrasives, a special cutting guard
(accessory) must be used.
When cutting in stone, provide for sufficient dust extraction.
Use only the blade guards and clamping nuts provided or spe-
cifically released for this power tool.
Technical Data
High-frequency Angle Grinder
Article number
Rated voltage
Frequency
Rated power input
Rated power output
Nominal current
No-load speed
Max. diameter for diamond cutting discs
Cutting discs width, max.
Grinding disc diameter, max.
Thread of grinder spindle
Weight according to EPTA-Procedure 01:2014
– with vibration-damping auxiliary handle
Protection class
Degree of protection
Notes on the Power Supply
The power tool is part of a high-frequency system and re-
quires three-phase current with a frequency according to the
type plate.
1 609 92A 36N | (9.12.16)
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 On/Off switch
2 Auxiliary handle
3 Grinder spindle
4 Spindle collar
5 Direction-of-rotation arrow for grinding spindle
6 Blade guard
7 Screw for adjustment of protection guard
8 Encoding key
9 Clamping lever for protection guard
10 Mounting flange
11 Grinding wheel
12 Clamping nut
13 Face plate
14 Cable strain relief (CEE plug)
15 Plug insert (CEE plug)
16 Screw (CEE plug)
17 Screws in plug insert 15 (CEE plug)
18 CEE plug
19 Plastic sleeve (CEE plug)
20 Hex key*
21 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
0 602 335 004
V 135
Hz 200
W 2500
W 2000
A 13.2
-1
min 4800
mm 300
mm 3.5
mm 300
M14
kg 10.9
/I
IP 20
To reach this frequency, the power tool must be connected
with a frequency converter (see "Connection to the Power
Supply", page 20).
0 602 335 034
200
300
3800
3000
13.2
5050
300
3.5
300
M14
10.9
/I
IP 20
Bosch Power Tools