Install Side Panel - Kitchen Aid Architect Series Guia De Instalacion

5. Remove the 2 door stop screws.
To remove the outer screw ("A"):
With the door closed, firmly press the L-shaped bracket
toward the center of the refrigerator until the screw is
exposed.
To remove the inner screw ("B"):
Open the door 90° and the L-shaped bracket will expose
the screw.
A
A. Door stop screw "A"
B. Door stop screw "B"
6. Reverse or rotate the door stop to the desired position as
shown below.
NOTE: For Overlay Series models, rout the hinge side of the
custom door panels to a radius that is equal to at least half
the thickness of the panel if a 130° door swing is desired.
130°
90°
Left-hand as shown; Right-hand
reversed
7. Replace the door stop screws and tighten.
8. Check that the door can open freely.
If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
1. For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
2. Nail the rear edge of the panel to the support board.
B
110°
90°

Install Side Panel

A
B
A. Support board
B. Side trim piece
27