Cooper Lighting N175MV Instrucciones página 5

N175MV_325-1511.qxd
What to do if...
LIGHT DOES NOT
COME ON
O R
LIGHT COMES ON FOR
O N LY A FEW SECONDS
LIGHT STAYS ON
OR
LIGHT CYCLES ON
AND OFF
Call for customer service and/or missing or damaged parts (800-334-6871)
11/1/05 2:24 PM
Is there power to the fixture?
• Has the circuit breaker tripped?
• Is the wall switch ON?
Is the bulb screwed in completely?
• Is the bulb good?
(Be careful not to overtighten.)
Is the sensor functioning properly?
• Is the sensor locked in place?
• Is light being reflected into the sensor, causing the
fixture to turn off?
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CHECKING
• Is the unit properly grounded?
Is the light sensor receiving enough light?
• Change the direction of the light sensor by
loosening the screw in the center of the sensor
receptacle. N O T E : Do not loosen screw more
than 1-1/2 turns. After loosening screw, carefully
turn receptacle in desired direction. Tighten
screw and reinstall sensor. Do not rotate more
than 360 degrees.
Page 5
5