Using The App - Revell Control VR SHOT Manual Del Usuario

Always observe the sequence when switching on! When switching off, always switch
off the model before the transmitter.
Install the free app to operate the model:
Switch on the model:
1. Slide the camera forwards to detach it (see 6A).
2. Unscrew the securing screw of the battery compartment cover and
slide it back to open it (see 6B).
3. Push the battery into the battery compartment. Insert the battery cable
in the connection cable on the model (7A).
4. Close the battery compartment cover and secure it with the screw (7B).
5. Fit the camera on the battery compartment cover (7C).
6. Then switch the ON/OFF switch on the model (1F) to ‚ON' . The LEDs on
the model start to blink.
7. After approx. 30 seconds, the model has activated a WLAN hotspot
(HelicMax-XXXXXX). Connect your smartphone to it.
Important! When switching on your model, always place it on an even
horizontal surface – the control electronics aligns its neutral position to
the subsurface.
Switch on the remote control:
1. Set the ON/OFF switch on the transmitter (2F) to the „ON" position. The power LED
(2G) on the transmitter illuminates.
2. Move the control for thrust and rotation (2C) completely up once and
then completely down again to unlock the transmitter. The model is
now ready to start.
Switch off the model: Then switch the ON/OFF switch on the model (1F) to the ‚OFF'
position. Remove the battery from the model.
Switch off the transmitter: Set the ON/OFF switch on the transmitter (2F) to the
‚OFF' position.
Note: Some functions of the app are not intended for this model and are deactivated.
Start the app and select ‚HD' .
Important functions:
8A Back to the app start screen
8B File management
8C Motion Control on/off
8D Button for flight speed
(40%, 70%, 100%)
8E Button for motor start
8F Photo button
8G Video button (recording on the smart
phone)
8H Video button (recording on SD card)
8I Adjust view
20
7 START PREPARATION

8 USING THE APP

8J Trim for forwards/backwards
8K Control for forwards/backwards and
banking
8L Not assigned
8M Trim for banking
8N Not assigned
8O Trim for rotation
8P Not assigned
8Q Control for thrust and rotation