Repair And Replacement - TomTom LINK 20x Guía De Instalación Básica

regulations of the country in which the vehicle is operated.

Repair and replacement

Repairs must be carried out by authorised and qualified personnel only. Never replace
damaged parts of the unit yourself. Send the defective unit to TomTom Telematics for repair.
Only the qualified staff of TomTom Telematics are authorised to repair or replace parts.
Damage to the device
Short-circuits inside the unit can be caused by contact with water or other liquids. The unit
may be damaged by contact with water. Use and store the unit in an area protected from
water.
How to install the TomTom LINK 20x in your vehicle
1. Go to telematics.tomtom.com/activation to activate your LINK.
2. Make sure that the vehicle ignition is off.
3. Locate the OBD-II connector of your vehicle. The image shows where it is generally
located. If you are not sure where to find it, please refer to your vehicle manual or
contact your car dealer.
4. Plug LINK into the OBD-II connector. Make sure it fits tightly. The red LED should turn
on.
Now you are ready to use the your LINK.
Note: For some vehicle models, the LINK requires calibration. You can find more
instructions in the LINK Reference Manual available on http://telematics.tomtom.com/
guides/
EN 6