Mr. Heater MH25NG Instrucciones De Uso Y Manual Del Usuario página 7

as follows:
3 for dimensions, locate a stud, and drill two
1/4"-20x3/4" HEX-
24" MIN
HEAD BOLT
HEATER WALL
MOUNTING
BRACKET
9"
GAS
CONTROL
VALVE
1/4" X 2-1/2" LONG
LAG SCREWS
(2 REQUIRED)
58"
Mr. Heater / Infrared Workshop Heater
Figure 3. Heater Mounting Information
CEILING
HEATER
MOUNTING
CLIP
1/4"-20
HEX NUT
1/2" NPT GAS INLET
(DO NOT EXCEED 1/2 PSI)
THERMOSTAT CABLE
(SEE FIGURE 4)
#6 X 1" SHEET METAL SCREWS
(2 REQUIRED - INCLUDED WITH
THERMOSTAT)
THERMOSTAT (SEE INSTRUCTIONS
INCLUDED WITH THERMOSTAT
FLOOR
the instructions that come with the thermostat for
included with the thermostat, and mount the
FLUE
DEFLECTOR
HEATER
REFLECTOR
UNFINISHED
SIDE
FLANGE
PREDRILLED
HOLES
Installation instructions and Owner's Manual
FINISHED
SIDE