Ratio ARC 18 LIT M2 Manual De Instrucciones página 36

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE OR INSTALL BATTERY PACK
(SEE A1)
Depress the Battery Pack Release Button firmly
first and then slide the Battery Pack out from
your tool.
A1
C) TO INSTALL THE BATTERY PACK (SEE FIG A2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
A2
36
D) How to charge your battery pack (SEE FIG
A3)
A3
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger base
to make the connections. And the red light
will illuminate to show charging has started.
3) After charging approx 1 hour, the red light
will be off , and the green light will still be on,
which means the battery is full, and charging
is completed. Then press the battery pack
release button and remove your battery
pack.
NOTE: This charger is designed to detect some
problems that can arise with battery pack. (see
table below
CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center. If the new
battery pack displays the same problem as the
original Battery Pack, have the charger tested at
an authorized service center.
Light Measure
Green on - - - -
Red on - - - -
Green on
Green on - - - -
Red off
OPERATION
1. HOW TO USE THE BELT CLIP (SEE FIG.
B1 B2)
Status
Charger is plugged
into the socket
without the battery
inserted.
Charging
Fully Charged