Looking Inside; Fresh Food Compartment - Amana ATB1504ARW Guía De Uso Y Cuidado

Looking Inside

Fresh Food Compartment

Shelves (style may vary)
CAUTION
To avoid personal injury or property damage:
• Never attempt to adjust a shelf when it is loaded
with food.
• Confirm that shelf is secure prior to loading items
onto it.
• Handle glass shelves with care. Shelves may
break suddenly if nicked, scratched or exposed to
sudden temperature changes.
Select models are equipped with wire or glass full
width shelves that are supported by rails molded into
the interior walls of the fresh food compartment.
These shelves can easily be adjusted to alternate
positions within the compartment.
To Adjust a Full Width Shelf:
• Grasp each side of the shelf.
• Pull the shelf forward approximately 1".
• While supporting the
shelf from underneath,
lift it up and out.
• Slide the shelf into the
desired alternate
position.
Shelves in other models hook into support rails located
on the back wall of the fresh food compartment.
To Remove:
• Slightly tilt up the
front and lift up the
rear of the shelf, then
pull the shelf straight
out.
To Lock Into Another Position:
• Tilt up the front edge of the shelf.
• Insert the hooks into the desired frame openings and
let the shelf settle into place.
• Be sure the shelf is securely locked at the rear.
• On certain models the outside edge of the shelf rests
on rails formed into the side of the fresh food
compartment.
The bucket-style Door Shelves accommodate a variety of
container sizes and shapes.
To Remove:
• Grasp the shelf on each end.
• Lift the shelf up and out.
To Reinstall:
• While holding the shelf on each end, slide the shelf in
and down.
• Push down on the interior center of the shelf to snap it
completely into place.
The Crispers provide a storage area for fruit and vegetables.
Some crisper drawers have slide humidity controls.
For fruit storage, slide the control (select models) to the left
to provide lower humidity conditions in the drawer.
For vegetable storage, slide the control (select models) to the
right to provide higher humidity conditions in the drawer.
For best results, keep the crispers tightly closed.
To Remove:
• Pull out the crisper until it stops.
• Tilt the drawer up slightly and pull it out.
To Reinstall:
• With the drawer tilted up slightly, align the drawer in the
tracks and slide in.
The Crisper Top serves as the lower refrigerator shelf.
To Remove:
• Remove the crisper drawers.
• Slightly lift up the front of the shelf.
• Support the shelf from underneath to lift it up and then out
of the cabinet.
To Reinstall:
• With the shelf front tilted slightly upward, carefully insert
the crisper top back into the cabinet.
• Position the rear and sides of the shelf on the supports and
let the crisper top settle into place.
8