Troubleshooting - Silverline Silverstorm Manual Del Usuario

GB

Troubleshooting

Problem
Red and green LEDs do not
illuminate to indicate the battery is
correctly charging
Battery pack has low capacity
Drill cannot be switched on (Trigger
Switch (7) does not move)
Drill does not start when Trigger
Switch is depressed
Screws do not reach deep enough
into the workpiece
Screws are driven too deep into the
workpiece surface
8 8
Possible cause
Battery not correctly connected to charger
Charger not powered
Battery not being fully charged
Battery pack has been charged over 100 times and capacity
has started to reduce
The Forward/Reverse Switch may be in the
middle ('locked') position
Battery completely discharged
Defective battery
Tool defective
Not enough torque; torque clutch setting too low
Low battery voltage
Too much torque; torque clutch setting too high
Solution
Clean battery socket of charger and battery contacts and fully slide on to charger so
it clicks in a locked position
Recheck mains connection
Do not remove battery until a full charge is indicated
This is normal for battery packs. Contact your Silverline dealer to purchase a
replacement battery pack
Slide the Forward/Reverse Switch either to the left or right
Recharge battery or replace with a fully charged battery
Replace battery
Contact your Silverline dealer or authorised service centre
Choose a higher torque setting
Recharge battery or replace with a fully charged battery
Choose a lower torque setting