Operation Instructions; Control Panel Instructions - Danby DDR030EACWDB Guía De Utilización Y Cuidado Para El Propietario

Ocultar thumbs Ver también para DDR030EACWDB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions

CONTROL PANEL INSTRUCTIONS

1
When you push the button to change operation modes, the unit will make a beeping sound to
indicate that it is changing modes.
1. Filter Button and Indicator Light: The check fi lter light will illuminate after 250 hours of opera-
tion. After cleaning the fi lter, press the fi lter button to reset this function and the light will go off.
2. Fan button and Indicator Light: Controls the fan speed. Press to select either low or high fan
speed. The indicator light will illuminate on high fan speed and will turn off on low fan speed.
) Buttons: The humidity level can be set within a range of 35% RH (Relative Humidity) to
3. (
/
80% RH in 5% increments using these buttons. For drier air, press the ( ) button and set to a
lower percentage value (%). For more damp air, press the ( ) button and set a higher percentage
value (%).
4. Timer Button and Indicator Lights: Press to initiate the auto-start and auto-stop feature. Set a
start or stop time from 0.0 to 24 hours using the ( ) and ( ) buttons.
5. Power Button: Press to turn the dehumidifi er on or off.
6. Bucket Full Indicator Light: When the bucket is full or incorrectly positioned inside the unit, the
bucket full light will turn on and remain on until the bucket is emptied or correctly re-positioned.
The compressor and fan motor operation will stop. When the bucket is emptied or correctly reposi-
tioned, the dehumidifi er will resume operation automatically.
Note: It may take 2-3 minutes before operating conditions resume.
7. Continuous Mode: To reach continuous mode, press the ( ) button until CO shows on the dis-
play. This setting will disregard the ambient humidity and will run the compressor continuously to
reach the driest conditions possible.
8. Display: Shows the actual (± 5% accuracy) room humidity level in a range of 35% RH to 80% RH.
Otherwise, displays selection when programming humidity or timer.
Note: The fan does not shut off the moment you remove the bucket, the fan will shut off after
2-3 minutes.
2
8
4
3
5
7
6
5

Publicidad

Tabla de contenido
loading

Tabla de contenido