Teleco TVPLA868CC2EN Manual Del Usuario página 13

Activation/deactivation of the RAIN sensor by means of the transmitter ***
Deactivation
Press the "STOP" button of a memorized
7/42 or 3-channel transmitter for 10 s. The
buzzer emits 2 beeps. L4 flashes once
every 2 seconds.
Change of the automatic alarm angles
4.5 1.1
Use the following procedures to change the default angles of the pergola slats associated with the wind alarm (33%) or the temperature/snow alarm (66%).
The system must have been configured and at least one transmitter memorized.
Wind alarm
angle
desidered
Temperature
position
or Snow
Put the slats to the
alarm angle
desidered angle,
then:
Reset
default
angles
Press P1 or P2 (**) as many times as required by the type of desired memorization and hold the last time.
The buzzer emits a continuous sound.
* The buzzer will make a beep each time the button is pressed.
NOTE: after a new configuration procedure the automatic alarm angles are always reset to default values.
STOP
L4 flashes
once every 2 s
(10 s)
*
x8
*
x9
*
x10
** According to the motor control mode *** The motor must be stopped **** The motors make short movements
Activation
****
Press the "STOP" button of a memorized
7/42 or 3-channel transmitter for 10 s.
The buzzer emits a continuous sound
for 4 seconds.
P1 o P2 **
13
STOP
****
continuous
(10 s)
sound 4 s
HOLD
(5 s)
continuous
sound
1 s
continuous
sound
2 s
continuous
sound
3 s